Ninja H2 banner
1 - 20 of 48 Posts

·
Registered
Joined
·
867 Posts

·
Registered
Joined
·
350 Posts

·
Registered
Joined
·
867 Posts
What...did they build like...4 of them???:eek:
I ordered mine today. Front n rear and they had them in stock. I'll have them before I have the **** bike! Lol
 
  • Like
Reactions: Flipr and shotgun15

·
Registered
Joined
·
554 Posts
The early Ducati 916 and 996 have a 21.5 mm pin.

A sleeve of 21.5 mm ID and 23.5 OD would do the trick.

Larger Ducati 25.5 mm pin could also be turned down to 23.5 mm.
if its just the pin thats unique, would you consider manufacturing and selling to others?
 

·
Registered
Joined
·
220 Posts
if its just the pin thats unique, would you consider manufacturing and selling to others?
Would be easy enough to do.

I just made a slip on sleeve to go over my 21,5 mm pin.

23.5 - 21.5 = 1 mm wall thickness tube.

For quick and dirty, some electrical tape wrapped would do

as there was not much slack to take up.
 
1 - 20 of 48 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top