Ninja H2 banner
1 - 5 of 5 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter · #1 ·
Hi everyone,

As I have told in my introduction post, I’m building a 1/12 scale model of the road-going H2.
Tire Wheel Fuel tank Vehicle Automotive lighting

It’s slow-going since the build takes place alongside building a 1/12 Yoshimura-Suzuki 1986 GSX-R 750 long-distance racer.

Because of the unique engine, I plan on the fuel tank and side fairings to be removable to see the engine in all it’s glory. However, it also means I have to add a fair amount of details in the form of wiring, cabling and pipes.

Can anyone show me how the wiring harness is laid out along the frame? Because it’s a Trellis-frame it’s highly visible if done wrong. I do have a pdf of the Service Manual and the parts list but it doesn’t show where the harness goes exactly from front to rear.
Thanks in advance!

Cheers,
Erik.
 

·
Registered
Joined
·
6 Posts
Discussion Starter · #4 ·
I looked up my pdf service manual immediately, a bit confused because I hadn’t seen the routing pictures before.
Lo and behold! They were indeed there! I must’ve been looking with my butt…. 🤦‍♂️
Cheers, Erik.
 
1 - 5 of 5 Posts
Top