Kawasaki Ninja H2 Forum - Search Results
Advanced Search
Showing results 1 to 25 of 338
Search took 0.03 seconds.
Search: Posts Made By: Kawiguy454
Forum: Ninja H2 General Discussion   03-31-2019, 09:19 PM
Replies: 20
Views: 931
Posted By Kawiguy454
GoFaster, the cup/water analogy is not quite...

GoFaster, the cup/water analogy is not quite right for a few reasons. The six holes holes in the air tube are each 3/4" or about 19mm if you add up all that area you get just over 17 square...
Forum: Ninja H2 General Discussion   03-29-2019, 07:38 PM
Replies: 20
Views: 931
Posted By Kawiguy454
Before you try to get dual ram air going you may...

Before you try to get dual ram air going you may want to get single ram air working. The six holes on the air tube effectively dump the downstream tube pressure to = atmospheric.
Forum: Ninja H2 General Discussion   03-13-2019, 07:48 PM
Replies: 160
Views: 7,297
Posted By Kawiguy454
My first look at this stuff, From the Air-box and...

My first look at this stuff, From the Air-box and pipe pictures to me they both look more like manufacturing cost reductions then performance mods. the new airbox without a snout as part of the...
Forum: Ninja H2 General Discussion   02-15-2019, 01:54 AM
Replies: 12
Views: 850
Posted By Kawiguy454
Another possibility... If the chain tension is...

Another possibility... If the chain tension is too tight the oil film will wring out and the bushings will gall and wear out. If not mistaken there are oil squirters pointed right at the chain so the...
Forum: Ninja H2 General Discussion   01-21-2019, 04:13 PM
Replies: 11
Views: 598
Posted By Kawiguy454
Very generally If you can eek out any additional...

Very generally If you can eek out any additional ram air pressure on the inlet side it will be stepped up in the compressor for a net performance positive. some carefully thought out tests should...
Forum: Ninja H2 General Discussion   01-18-2019, 02:23 PM
Replies: 11
Views: 598
Posted By Kawiguy454
99.9% sure you'd be wasting your time. The holes...

99.9% sure you'd be wasting your time. The holes in the air tube next to the forks will bleed positive pressure from forming in the rest of the tube. Block the holes and maybe there will be something...
Forum: Ninja H2 General Discussion   12-02-2017, 12:39 AM
Replies: 87
Views: 5,080
Posted By Kawiguy454
I hear some good stabs at this let me add my...

I hear some good stabs at this let me add my $.02. Keeping in mind the division of kawi that engineered the SC was the gas turbine division and the space and weight limitations of the package...
Forum: What did you do to your Ninja H2/H2R today?   10-09-2017, 01:19 AM
Replies: 93
Views: 9,598
Posted By Kawiguy454
2 identical H2's/riders going down the road same...

2 identical H2's/riders going down the road same gear same speed. Modded bike has a few PSI less in the plenum and both riders hit it ...which bike will be on more power immediately? If it was a...
Forum: What did you do to your Ninja H2/H2R today?   10-09-2017, 01:07 AM
Replies: 93
Views: 9,598
Posted By Kawiguy454
You have to read the whole sentence. The point is...

You have to read the whole sentence. The point is that if you do a BOV mod to get cooler IAT but also lose some IAP the ~10 degree temperature/density difference is just not as significant as what...
Forum: What did you do to your Ninja H2/H2R today?   10-07-2017, 08:21 PM
Replies: 93
Views: 9,598
Posted By Kawiguy454
A simple reason you may lose some power at part...

A simple reason you may lose some power at part throttle is a mechanical valve with a specific set point will act mecahnically. A solenoid Kawi engineered for the job may work with a bit more IAP...
Forum: Tuning   09-04-2017, 05:15 AM
Replies: 21
Views: 3,513
Posted By Kawiguy454
6 x 1" holes equals 4.74 square inches of area...

6 x 1" holes equals 4.74 square inches of area ...that is a really big opening. Probably very close the cross sectional area of the tube itself at its narrowest point. There are formulas for...
Forum: Tuning   09-02-2017, 03:37 AM
Replies: 21
Views: 3,513
Posted By Kawiguy454
Ram air on H2R is part of the extra...

Ram air on H2R is part of the extra cost/performance. It is already a bike with everything you would add as far as full exhaust, CF intake tubes and cams. I believe Kawasaki would have also fine...
Forum: Tuning   08-31-2017, 12:43 AM
Replies: 21
Views: 3,513
Posted By Kawiguy454
I think they are there for two reasons. As a way...

I think they are there for two reasons. As a way to pull in air if the front gets some debris. but mainly to clamp down pressure in the tube to = atmospheric pressure at any speed. Or to put it...
Forum: Ninja H2 General Discussion   02-24-2017, 02:47 AM
Replies: 17
Views: 1,917
Posted By Kawiguy454
What exhaust is that? Look at the carbon in...

What exhaust is that? Look at the carbon in there, looks a bit much. ...could write "wash me" in it
Forum: Ninja H2 General Discussion   02-24-2017, 02:32 AM
Replies: 35
Views: 3,938
Posted By Kawiguy454
Sorry I missed your reply i don't check in as...

Sorry I missed your reply i don't check in as much as I used to. I haven't been riding H2 as much but need to ...tomorrow for sure :-). Probably 1000 miles on with some visible center wear from...
Forum: Ninja H2 General Discussion   02-08-2017, 01:44 AM
Replies: 15
Views: 2,301
Posted By Kawiguy454
+1 State Farm less than 300 for 6 months. Be sure...

+1 State Farm less than 300 for 6 months. Be sure to check liability levels though. They tend to be low $25k I bumped to $100k recently cause 25k would barely buy an overnight in a hospital these...
Forum: Ninja H2 General Discussion   02-01-2017, 12:36 AM
Replies: 35
Views: 3,938
Posted By Kawiguy454
I agree with everything you said about the...

I agree with everything you said about the Michelin's. The PP 2CT have a great profile for carving on the road and stuck like flypaper on my ZX14. I got the PP3's though on H2 cause they are a more...
Forum: Exhaust   01-31-2017, 11:51 PM
Replies: 24
Views: 4,519
Posted By Kawiguy454
Its actually quite easy, every +/- 3.0 db is 2X...

Its actually quite easy, every +/- 3.0 db is 2X or 1/2 as loud. So compared to ear splitting 115db, 112db is HALF as loud. And 109db is again half as loud as 112db and so on... 93db is considerably...
Forum: Tires   12-20-2016, 06:00 PM
Replies: 12
Views: 2,976
Posted By Kawiguy454
Similar experience with those same Michelin's on...

Similar experience with those same Michelin's on my street driven ZX14. I have 190/55 on the H2 now and they are confident and turn in well. The BS's seemed more neutral but not bad. I had a 190/50...
Forum: Ninja H2 / H2R Build Area   11-18-2016, 01:57 AM
Replies: 242
Views: 36,737
Posted By Kawiguy454
Have you ever seen one of these? Miniature BLDC...

Have you ever seen one of these? Miniature BLDC Rotary Refrigeration Compressors | 2012-10-23 | Appliance Design Magazine...
Forum: Tuning   11-16-2016, 03:00 PM
Replies: 19
Views: 2,742
Posted By Kawiguy454
IMO if you keep the stock catalytic converter and...

IMO if you keep the stock catalytic converter and the PAIR is disabled you may not get enough oxygen fed into the cat to fully burn the exhaust gasses inside. Superhot unburned gasses getting past...
Forum: Drivetrain   11-12-2016, 10:49 PM
Replies: 139
Views: 27,515
Posted By Kawiguy454
I was able to put mine on without breaking the...

I was able to put mine on without breaking the chain also. Its been awhile but i think I loosened the guide bolts and as Bob said put the chain over the sprocket before sliding it on.
Forum: Ninja H2 General Discussion   10-17-2016, 03:52 PM
Replies: 56
Views: 6,390
Posted By Kawiguy454
Got started at 18 as a navy submarine sailor and...

Got started at 18 as a navy submarine sailor and after continued upgrading to stints in industrial electronics repair and as a Cad designer and app support at Ford Motors. Today Sr IT support at a...
Forum: Ninja H2 / H2R Build Area   10-14-2016, 11:36 PM
Replies: 25
Views: 3,361
Posted By Kawiguy454
Dont know if it applies to your bike but look at...

Dont know if it applies to your bike but look at the frame rust thread and get those areas protected and closed up. If salt gets in there it could be bad pretty quick....
Forum: New Members Introduction   10-14-2016, 11:12 PM
Replies: 15
Views: 1,909
Posted By Kawiguy454
Have you sat on a ZX10? if you feel too small for...

Have you sat on a ZX10? if you feel too small for that one I'm sure H2 may be more uncomfortable. With your size/weight the H2 will just fly! Good luck!
Showing results 1 to 25 of 338

 
Forum Jump

Search Tags for this Page

ninja h2 forum

,
kawasaki ninja h2 forum
,
kawasaki ninja h2
,
ninja h2 specs
,
ninja h2 pics
,
ninja h2 msrp
,
ninja h2r
 
For the best viewing experience please update your browser to Google Chrome